Deprecated: Creation of dynamic property lastRSS::$cache_dir is deprecated in /www/wwwroot/forexconverter.org/00rss.php on line 45
Deprecated: Creation of dynamic property lastRSS::$cache_sqlite is deprecated in /www/wwwroot/forexconverter.org/00rss.php on line 46
Deprecated: Creation of dynamic property lastRSS::$cache_time is deprecated in /www/wwwroot/forexconverter.org/00rss.php on line 47
Deprecated: Creation of dynamic property lastRSS::$rsscp is deprecated in /www/wwwroot/forexconverter.org/lastRSS.php on line 234
L3 Build Log - Wildman Interceptor A. A. D. 98 - Rocketry Forum My L3 attempt will be with a Wildman Interceptor AAD 98 I have one TAP member on tap (couldn't resist, thanks Kurt) and am on the lookout for a second I have an Ultimate Darkstar kit on standby in the event I have to restart this process Hopefully not Also, I wanted to practice a few more
Motor delay adjustment | Rocketry Forum - Model Rocketry Forums I had to trim an accelerometer mounting (triaxial accel -> 2 leg magnet with no through-hole) using shim washers from good ol' McMaster-Carr I wonder if these could be a source for the needed 1 32" washer?
Warning about shipping with McMasterCarr - Homebrew Talk Just a heads up on being careful shipping stuff with McMasterCarr I needed a small piece of copper tubing to put the thermistors in for my vessels I ordered part number 8967K2 from McMasterCarr, along with a whole bunch of little fittings 8967K2 is a 6 foot long piece of 3 16" copper
FlyingGiants FlyingGiants ay isang online na komunidad para sa mga mahilig sa RC aircraft, pagbabahagi ng impormasyon, talakayan, at pagbili o pagbebenta ng mga bahagi
What RPM do you run your grain mill at? - Homebrew Talk I just was gifted a 5 HP 3450 RPM motor I've got a 2" Drive Pulley connected to a 8" Driven pully on a mandrel, which I'll attach to the barley crusher via coupling The resulting rpm is 862 5 or a 25 reduction How fast is too fast? I was hoping to keep with the 8", but if I need to, I'll
Launch Rod Length? | Rocketry Forum - Model Rocketry Forums My question pertains mainly to the Sport division, but I was wondering what would be the optimum launch rod length for 1 8th and 3 16th diameter rods? I have the old standard Estes two piece rods AND a 4' length of one piece in both sizes Seems the Estes rods aren't long enough to accomodate
What gauge nichrome for DIY igniters? - Rocketry Forum As I said before 30ga has been the standard for Igniter making for decades If someone wants to make their own igniters buying a 1 4lb roll of 30gauge 0100" dia Nichrome is the cheapest way to go I get mine from McMaster-Carr
What do I cut piano wire with? - Rocketry Forum Hi all, Hopefully somebody can point me to the right tool Even the thin piano wire is really hard and repeated cutting has ruined three of my cutters What do you use to cut thin piano wire?
T-nuts for 20 Series rail - Rocketry Forum I think I need to go with a simple flat square nut of some kind The self-aligning nuts for 20 series are iffy or not found, even at McMaster-Carr